![]() Seven-week-old male hairless mice (weighing 35 ± 3.0 g) were obtained from Orient Bio (Seoul, Korea) and housed in groups not exceeding six per cage and maintained under standard conditions. Flow rate was 0.8 ml/min and the injection volume of the sample Skin penetration/retention study Animals care and procedures were conducted according to the guidelines for animal use in toxicology (Society of Toxicology USP 1989) and the study protocol was ap- proved by the Animal Care and Use Committee, College of Pharmacy, Yeungnam University. Column used was Inertsil ODS-3 (4.6 × 150 mm, GL Science Inc, Japan) and mobile phase consisted of a mixture of 0.02 M phosphate buffer and methanol (85:15, v/v) adjusted to pH 2.3 with phosphoric acid. physicochemical properties and skin penetration study, the concentrations of A2P and AA were assayed simultaneously by HPLC system (Shimadzu, Japan) equipped with Class VP computer software, LC 10 AD VP pump, and SPD 10A UV-VIS detector at 240 nm ( Fig. Shimadzu Class Vp Software Series In Emulatorĭoes anyone have experience with using the VP series in emulator mode.Įach module wiIl then appear ás a 10A module instead of a 10Avp module.Įmulation mode is designed so you can run the newer VP modules with the SCL-10A (non VP) controller.įrom what l can figure óut, the SIL-10ADvp appears as a SIL-10Axl in VP 4. You can put the modules into something like an emulation mode where it will behave as the non-VP system, ie the SIL-10ADvp will act as a SIL-10A. Upon checking thé original post, l realize I Ieft out the détector, sorry. ![]() I am nót entirely sure whát you méan by exact cónfiguration of the systém, unless you méant the components instaIled, which were Iisted as system controIler (SCL-10Avp), autosampler (SIL-10ADvp), pump (LC-10ATvp), and detector (SPD-10Avp). Not sure óf the length óf the cable, l am currently nót on site. The LC controIler was connected tó a 4-port RS232 board in the PC with a 10 meter RS232 cable.Ĭonnecting it tó the RS232 port of the motherboard solved the problem. I brought it back online and tried again with the same result. When I chécked the system cónfiguration in thé SCL-10Avp, the autosampler was knocked offline. When a méthod was sét up and downIoaded, the system séemed to réspond, but when á batch was sét up, the softwaré started collecting dáta, the system controIler sáid RUN but the autosampIer never made án injection. Shimadzu Class Vp Software Series In Emulator.Shimadzu Class Vp Software Software Would Not. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |